You have to immediately fix the hot water tank as it starts to leak. In less than a day, we will teach you how to mount your gas water heater. And if you do not need a modern heating system just now, over the next few decades, odds are you will. Seven to 15 years of heating systems tend to last. If it is getting old, this paper is for you, too. It is not difficult to replace a hot water tank if you are comfortable with simple equipment and have a little copper welding expertise.
Let’s look at the steps to Hot Water Tank Installation and Replacement:
Step 1: Shutting off the gas and water
Turn off the gas on the heating system by trying to turn a quarter turn on the neighbouring shut-off valve. The grip must be at a right angle to the tube when off. By using a water tap on the lowest level, cut off the primary water source also and clean the tubes.
Step 2: Drain the water in the tank
To the drain valve, connect a garden hose and drain the water left in the tank. Warn: The water is going to be boiling! Remove the gas line with a set of screws at the nearest intersection and disassemble the tubing with a pipe wrench from of the fuel relief valve.
Step 3: Cut off the water lines
From the vent cover, disassemble the vent pipe and transfer it to the left. With a pipe cutting tool, then split the cold and hot water sections. (Unscrew reinforced pipe units or the bolts if you get them on adjustable cables.) Move the older heating system out of the path.
Step 4: Attach the relief valve
Cover with Teflon tape (three turns) the wires of the latest heat and relief valve. Rile it securely into the reservoir with a power drill. Connect a drainpipe of copper.
Step 5: Attach the pipe assemblies
Weld to 6-in copper wire connectors. 3/4-in-lengths. copper and drive the modules into the hot water exit and cold-water inlet terminals in the top of the tank. To protect from corrosion products, add small, plastic-lined tips, especially if you do have rough water or if regional regulations need them.
Step 6: Attach the water lines
Slip right the fresh heating system into position, retooled the aged piping or broaden it to implement the changing one, and use copper roll pairings to weld the piping together. Offset the sections as required with combinations of 45-degree forearms if the piping does not match up.
Step 7: Reattach the vent
Then, reconnect the vent. Place it properly over the hood of the draft and stable it properly. Predrill the holes. The vent should properly rise to at least a few inches.
Step 8: Attach the gas line
Finally, reconnect the gas line. Using the tube joint compound to cover the pierced edges and insert the first tip into the gas valve. To stop stressing the tube, use two pipe spanners. Reconfigure the existing tits, completing the alliance.
Step 9: Check for any leaks
Switch on the gas and check for any type of leaks. If bubbles are forming at the junction, this shows the presence of the leaks. Tighten the joints once the leak is found and dry the joints by wiping it properly.
